CCDP/ Cisco ARCH (v.3): Further Readings

It may be that due to the nature of this course – focusing on theory and design instead of digging into command and “computer architecture” kind of topic, it may be good for 300-320 ARCH exam but explanation given was not clear for a techie. Below are some of the contents I found useful to enhance my domain knowledge complimenting Cisco CLN E-Learning: Designing Cisco Network Service Architectures (ARCH) v3.0 (Other Learning Resources here )

More links will be added here, so come back from time to time 🙂

Last Update: 2016/07/13 – Including readings for Ch23 Designing Firewall and IPS Solutions

» Continue reading “CCDP/ Cisco ARCH (v.3): Further Readings”

Comments off

Cisco ARCH (v.3) Learning Resource

Last Update: 2016/07/13 – Including link to my new blog post “CCDP/ Cisco ARCH (v.3): Further Readings

Almost three years since the last re-certification… Originally I would like an CCIE R&S written but as I don’t have enough time now, I decided to go for ARCH v.3 (300-320) instead. Resources are petty limited…. 🙁

Syllabus

Official Self-Study Material

Supplement

Materials from 3rd party

Material for previous generation of exams

 

Note: CLN = Cisco Learning Network

Comments off

Cisco WLC Upgrade Outline

Study the Release Note completely is the most important thing – especially the Open Caveats and downgrade limitation

  1. Check upgrade requirement
    1. Any need to upgrade FUS?
    2. Any need to upgrade to an interim SW version before further upgrading to the target SW version
    3. Open Caveats that hits the setup of our environment and the impact
    4. All APs are supported in the latest firmware? Any bug for any AP model?
    5. Fallback – Issue to hit if we downgrade from this version to the earlier version
  2. Prepare Image(s) – FUS & OS SW
  3. Pre-check & Implementation
    1. AP inventory – “show ap inventory all” <- check number of APs and who are they
    2. Check number of wireless interfaces being down
    3. Download WLC SWs to the WLC
    4. Check boot sequence – “show boot”  (the new image should be the primary image)
    5. Pre-download – “config ap image predownload”
    6. Check the pre-download status – “show ap inventory all” / GUI: Wireless > Access Point > All AP
    7. Reboot the controller – GUI: Commands > Reboot
  4. Post-check
    1. Check number of APs and who are they
    2. Check number of wireless interfaces being down
    3. Sample check a few APs Flexconnect group & VLAN mapping if any

 

Reference
my80211.com, WLC: Predownload The Image To The Access Points From The Controller CLI – http://www.my80211.com/cisco-wlc-cli-commands/2011/2/20/wlc-predownload-the-image-to-the-access-points-from-the-cont.html

(Used to upgrade from 8.1.110.0 to 8.2.100.0)

Comments off